Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE door at the left side of the machine, remove 4 an 4 - 25 Replacing Elem 1. Open the re hooks (2), th 2. Hold the out er element (5), rock it lightly up and down and the left and ri ght, and rotate the element t o the left and right pull it out. Do not remo ve inner element (6) when d 3. When the ou ter element (5) has been rem oved, check that t inner elemen t has not come out of posi tion and is not at angle. If is at an angle, insert your hand a 4. Wipe off or b rush off the dirt stuck to cove r (3) and the inside the air clean 5. Remove any dirt or dust that is accumulat (4) installed t NOTICE The inner eleme nt must not be cleaned and us ed again.

When replacing the outer element, repl ace the inner element at the same time. If the inner elem ent is not installed properly and t he outer element an d cov er are installed, there is d anger that the outer element will be damaged . The seal portion on imitation parts lacks precisi on, and allows the e ntry of dust, which leads to d amage of the engine. Do not use such imitati on parts. 6. Remove inne r element (6), then quickly i nstall the new inne Insert the inn er element securely so that it does not move. 7.

Push the ne w outer element (5) in straigh t with your hand when installing it to the air If the elemen t is held and rocked lightly up and down and to the l eft and right while pus hing it in, the element can be inserted e