. MAINTENANCE MAINTENANCE PROCEDURE 4 - 47 NOTICE If the air is no t bled from the swin g motor, the motor bea rings may be When replaci ng the travel motor s afety valve, please con tact your Kom atsu distributor to have it r eplaced and to have the air bled. 5. Bleeding a ir from travel moto (Bleed the air only when the oil inside the travel motor case h 1) Run the engine at low idle, loosen air bleeder (4), and tighten it when oil flows out. (Bleed the air only when the oil inside the travel m otor case h 1) Run th e engine at low i tighten it when oil flows o 2) Run th e engine at low idl e and swing the wor k equipmen 90 deg rees to bring it to t he side of the track.
slightly from 3) Jack u p the machine unti l the track is raised the gro und. Rotate the tra ck under no load fo r 2 minutes. Repea t this procedure on both the left and rig ht sides, and rotate t he track equally b oth forward and in re verse. 6. Bleeding a ir from attachment (when installed) I f a breake r or other attachme nt has been installed , run the en gine at low idle and opera te the attachment peda repeatedly (approximately. 1 0 times) until the air has been bl ed from the attachment c ircuit. NOTICE If the method of bleeding the air f rom the attachment its elf is specifi ed by the manufacturer, ble ed the air according to the specified pro cedure.
After complet ing the air bleeding o peration, stop the eng ine, and leav e the machine for 5 minutes before starting operations. This will remo ve the air bubbles in the oil inside the hydr aulic cylinder Chec k that th ere is no leakage of o il and wipe off any oil that has been After complet ing the air bleeding o peration, inspect the o il level, and i f the oil level is low, add oil.