Komatsu — EVERY 1000 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE REMARK It is not necessary to remove the plug at the top of the fuel pre-filter and fuel main filter. After the engine the same procedure to it. 4 - 72 Bleed the air as f 9. Fill the fuel ta nk with fuel (to the positio n where t he float is at the hi 10. Loosen the k nob of feed pump ( 4), pull the movement becomes h eavy ne runs out of fuel pump (4) and bleed , use t the air 11. Push in the k nob of feed pump ( 4) and tighten it. 12. After replacin g the filter cartridge , start the engin e and run it at low kage of oil from the filter se al surface . If any oil is leakin g, check the tightenin g of the filter cartridge.

l oil leakage, repea t Steps 1 to 4 to remove t he filter c artridge, and if any damage or embedded ial in the packing su rface is found, re place it wi th a new cartridge and repeat Steps 5 to 12 to install (Machine of poor fuel arrangement s pecification REMARK Sometimes some air is still left inside water separator after air b leeding, but the engine can b e started by operating feed pump (4) un til its motion gets h ard. Th e remaini ng air is n aturally b led when the water separator is left as it is for some time aft er the engine come s to a s top.