. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 4. Loosen water drain plug (4) to completely drain fuel in the casing. 4 - 74 5. If f uel is not draine d, remove air intake plu g (5). (Width a cross flats: 14 mm) 6. Disconnect drain h 7. Loosen ring nut (6) to remove casing (7). 8. Remove screen (8) from the water separa tor table, pullin g the screen out downwa rd. ith clean fuel. 9. Wash screen (8) w At that time, also ch eck it for damage and i f any, replace i t with a new one. 10.
Wash the interior o f casing (7) for damage , a crac k or s o bad a c ontamination as to make it impossible to identify t he loc ation of float (9), and if a ny of them is found, repl ace the casin g with a new one. n the water separator table. ) with a new one. in plug (4). 11. Install screen (8) o n the water separator ta 12. Replace O-ring (10 13. Screw in water dra Tightening torque: 1.5 to 2.5 Nm (0.15 to 0 .25 kgm , 1.1 t o 1.8 lbf t) 14. Pu t float (9) in casi ng (7) the way it does n ot tilt, an d then pour clean fuel in the ca sing calmly. 15. Install casing (7) on the water separator ta ble and t ighte n ring nu lbf