Komatsu — EVERY 2000 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE CHANGE OIL IN FINAL DRIVE CASE WARNING 4 - 77 EVERY 2000 HOURS MAINTENANCE Carry out the periodic maintenance work of every 100, 250, 500, and 10 00 hours of operat ion at the same ti The parts and oil are a t high temperature immediately after the engine is stopped, an d may cause s erious burns. Wait f or the temperature to go dow n before starting the operation If there is still pressur e remaining inside the case , the oil or plug may f ly out. Loosen the plug slowl y to releas e the pres sure. Please do not stand in front of the plug whe n you loosen th e plug Refill capacity PC200 (each): 3.3 l PC220 (each): 5.2 l Prepare a handle. 1.

Set the TOP mark at the top, with the TOP mark an d plu g (P perpendicular to th e ground surface. 2. Set a container un der plug (P) to catc h the oil. 3. Remove plugs (P) and (F) with the handle and drain the REMARK Check the O-rings in t he plugs for damag e. If necessar with new ones. 4. Tighten plug (P). e hole of plug (F). 5. Add oil through th 6. When oil begins to overflow from the p lug ( F) h ole, i nstall plug (F). of plugs (P) and (F): 1 kgm, 50.6 ± 7.2 lbft) Tightening torque of plugs (P) and (F) 68.6 ± 9.8 Nm (7 ± 1 kgm, 50.6 ± 7.2 l REMARK There are 2 plugs (F). Add oil through the one easier to fill oi l and through which no inter nal gears are to be seen .