. MAINTENANCE MAINTENANCE PROCEDURE METHOD OF RELEASING PRESSURE IN HYDRAULIC CIRCUIT 4 - 82 1. Plac e the wor k equipment o n the ground. C lose the crusher attachment j 2. Operate the w ork equipmen t lock leve r to th e LOCK position. 3. Inse rt the loc k pin for the at tachment c ontro l pedal i n position (c) w here it is possible to op erate the pedal. (If e Carry ou t Steps 4 to 6 within 15 seconds. When th e engine is stopped, the pressure i n the accumulator gradually goes do wn. For thi s reason, the release can only be carried o ut immediately after the e ngine is stopped. 4. Stop the engi 5. Turn the start ing switch to O N position 6.
Set lock leve r to FREE po sition (F), then d the attachme then operate the work equipment co ntrol levers an nt contro l peda l (if equipped) full y to the front, rear, left, and right to release the it. lease the pressure in th e control circu 7. Set the lock l ever to the LO CK positio n, the n turn th e starting switch to O FF position. 8. Inse rt the lock pin in position (a) so tha t the a ttachme nt control ped al cannot (If e