Komatsu — TRAPEZOIDAL BUCKET

. ATTACHMENTS AND OPTIONS ATTACHMENT GUIDE of the is different ditch slope face angle (45 degrees, 40 Digging Work Operate the boom, arm, and bucket so that line (1) of the side plate of the bucket is always perpendicular, then carry out digging. Horizontal calculation plate (2) is welded to the bucket pin hole portion, so when digging, operate so that the plate is horizontal during the digging operation. Ditch slope face 45 degrees Use the bucket only or install the variable plate using the ditch slope angle holes, and use the method above for digging. 6 - 30 The position of installation degrees, 38 degrees).

variable plate for each Ditch slope face Mounting bore (A) (B) (C) (D) (E) 45 degrees { - { - - 40 degrees { { - { - 38 degrees { { - - { Item Ditch slope face(F) 45 degrees Digging width (top side)(G) 3,165 mm (10 ft 5 in) Digging depth (H) 1,385 mm (4 ft 7 in) Digging width (bottom side)(I) 400 mm (1 ft 4 in)