OPERATION 16.4 METHODS OF TOWING MACHINE I A WARNING I When using a chain or cable, be sure it is strong enough for the expected load and it is properly secured to the drawbar pins or tow hooks (if equipped). When pulling with a chain or cable, take up the slack slowly to avoid jerking. A chain or cable which fails under load can whip and cause serious injury. Stand clear. Do not pull or tow unless the operator’s compartment is guarded against or out of reach of a whipping chain or cable. Attach only to the machine tow hook or drawbar. Failure to follow these instructions could cause serious injury. I REMARK If the steering drive, final drive or tracks are damaged, do not tow.
The machine must be transported on a carrier to avoid further damage. To avoid the possibility of power train damage, limit the towing to a distance of 0.8 km (0.5 mile) at speeds less than 1.6 km/h (1 mph). The brakes on this machine are automaticly spring applied when the engine is stopped. The brakes can only be released hydrauli- cally. A towing port for applying external pressure to release the brakes is located in the battery box below the drive train filter. If the machine can be towed and the engine and steering hydraulic system can be operated, proceed as follows: 1. Position the safety lock lever in the down position. Start the engine. Use a towing cable of sufficient strength.
Keep the engine running at half throttle and the safety lock locked in the down position during the tow. If the machine can be towed but the engine and/or steering hydraulic system is/are inoperable, proceed as follows: 1. Open the battery box door. Modify a grease gun by installing a female quick disconnect fitting and a hose of sufficient length to allow operating the grease gun from the operator’s seat for releasing the spring applied brakes. REMARK Do not intermix the male and female quick disconnect fittings with each other. Refer to Service Bulletin B 07C 89A for proper identification. 2. Pump sufficient grease into the fitting to release the brakes.
The amount of grease required depends on the amount of pressure of dissipation in the system. Use a towing cable of sufficient strength. During the tow, it may be necessary to pump more grease into the brake release fitting to replace the loss of pressure. I * WARNlNG I Stop towrng the machine before applying grease to fitting. 3. 4. Depressing the secondary brake pedal will relieve pressure and apply the brakes. When towing is completed, remove the grease gun and close the battery box door. 2-64