MAINTENANCE 24.8.2 CHANGING DRIVE TRAIN SYSTEM OIL 1. Remove the drain plug immediately after operation while the lubricant is still warm. Drain into a suitable container. A WARNING When working under the machine, turn off the electrical system master switch and tag the controls to warn against starting the machine. 2. After the system has been completely drained, reinstall and tighten the drain plug. 3. Remove the oil level gauge with cap. Pour lubricant into the rear frame through the filler tube to bring the level up to the FULL mark on the gauge. + For details of the oil to use, see 20 USE OF FUEL, COOLANT AND LUBRICANT ACCORDING TO AMBIENT TEMPERA- TURE on page 3-8.
24.8.3 DRAIN, FLUSH AND REFILL FINAL DRIVE OIL 1. While the lubricant is at operating or warm ambient tempera- ture, park the machine on level ground. Remove the drain plugs (1) and allow the lubricant to drain into a suitable con- tainer. Install and tighten the drain plugs. Remove the filler and level plug (2). Fill the housing with fuel oil up to the filler and level plug opening and install the pipe plug. 2. Operate the machine in low gear (with no load) for a few minutes. Remove the drain plugs and thoroughly drain the fuel oil into a suitable container. Reinstall and tighten the drain plugs. Remove the filler and level plugs.
Fill the housing with fresh lubricant up to the bottom of the filler and level plug opening. Reinstall and tighten the filler and level plugs. + For details of the fluid to use, see 20 USE OF FUEL, COOL- ANT AND LUBRICANT ACCORDING TO AMBIENT TEMPER- ATURE on page 3-8. 24.8.4 REPLACE DRIVE TRAIN SYSTEM BREATHER REMARK To prevent dirt from entering the critical areas of the transmis- sion system, keep the breather clean. Replace the breather, The breather is located on the transmission system filler tube. Unscrew the breather from the reducer nipple. Install the new breather on the nipple. 3-44