Komatsu — 24.11.10 GREASE CAB DOOR HINGES

24.11.8 ADJUST FRONT IDLER CLEARANCE 1. Measure gap A and add shims (1) to obtain a 0.152 to 0.762 mm (0.006 to 0.030 in) clearance (A). 2. Equalize gap B on both sides of the front idler. Measure gap C and add shims (2) to obtain a 0.152 to 0.762 mm (0.006 to 0.030 in) clearance (C). 3. Repeat steps 1 and 2 for remaining front idler. 24.11.9 CLEAN OR REPLACE CAB FRESH AIR FILTER 1. Open rear inspection cover (1) and remove filter. Wear eye protection when using air under pressure to clean parts. Limit air pressure to 206 kPa (30 psi). A WARNING 2. Clean filter with compressed air. If it is extremely dirty, wash it in a neutral agent.

After washing, dry it completely before installing it again. REMARK If clogging of the filter cannot be removed by washing or using compressed air, replace the filter with a new one. 24.11 .lO GREASE CAB DOOR HINGES Apply grease until clean lubricant is visible. Always use a clean lubricator and wipe dirt from fittings before fresh grease is applied. If grease fails to go through the fitting, determine the cause and correct it. After greasing, wipe off any old grease that was purged. 3-69