Komatsu — 24.13.2 PRIMING

MAINTENANCE When the air inlet hose is removed, the turbocharger can be damaged by entry of any foreign material during engine operation. When service work is completed, remove shield and store for future use. Reinstall air intake hose with hose clamp. As a precaution against dirt getting into the engine, frequently inspect the flexible rubber hose connections clamped to the turbocharger compressor housing. If signs of deterioration are evident, replace immediately. To eliminate undue strain on the rubber hose connections, insure that pipes are properly aligned. All the joints between the air cleaner and the turbocharger and between the turbocharger and the cylinder heads must be tight.

All the gaskets must be in good condition and the bolts must be drawn up tight. 24.13.2 PRIMING The turbocharger must be primed when the engine has been idle for more than 30 days or more. Prime the turbocharger as follows: Be sure the hydraulic lock lever is applied. Disconnect the lead to the engine fuel shut off solenoid. Turn the ignition switch to the START position. Crank the engine until oil pressure is indicated by the engine oil pressure monitor on the control console. This should provide and adequate amount of oil to lubricate the turbocharger. Cranking the engine must be limited to 30 second periods with two minute between periods. 3-74