Komatsu — 12.10.2 SMOOTHING

OPERATION 12.9.3 PRECAUTIONS WHEN TRAVELING UP OR DOWN HILLS Use Engine as a Brake When going downhill, shift gear shift lever into low speed to run engine at slow speed and travel down slope using the engine as a brake. Never coast down slope with the steering and directional lever in the N (neutral) position. Braking When Traveling Downhill While descending a slope using the engine as a brake, also apply the brakes. Failure to brake may result in overrunning, causing engine trouble. 12.9.4 PRECAUTIONS ON SLOPES Be Careful of Fuel Level If the fuel level in the fuel tank becomes low when working on slopes, the engine may intake air because of the angle or the swaying of the machine.

If this makes the engine stop, be careful not to let the fuel level in the fuel tank become too low. Precautions When Engine Stops on Slopes If the engine stops while working or traveling on a hill, immediately depress the brake pedal, lower the blade to the ground to stop the machine, then lock the brake pedal with the brake lock lever. Thereafter, move the steering and directional lever to the N (neutral),position, lock the lever, then restart the engine. 12.10 WORK POSSIBLE USING BULLDOZER In addition to the following, it is possible to further increase the range of applications by using various attachments. 12.10.1 DOZING A bulldozer digs and transports dirt in a forward direction.

Slope excavation can always be most effectively carried out by proceeding from the top downward. When dozing toward one side only, operate with angled blade. 12.10.2 SMOOTHING NOTICE Avoid smoothing on rocky or stony ground. It can damage the blade. Uneven ground surfaces remaining after digging can be leveled off by fine operation of blade. The basic method is to operate the machine at low speeds with the blade fully loaded with soil and sand. A flat finished surface is also possible by slowly backing the machine with the blade floating so it is dragged across the surface. However, avoid this on rocky or stony ground, as it may damage the blade. 2-45