OPERATION 16.3 OTHER TROUBLE ( ): Always contact your Komatsu distributor when handling these items. + In cases of abnormalities or causes which are not listed below, please contact your distributor for repairs. 16.3.1 ELECTRICAL SYSTEM PROBLEM MAIN CAUSE REMEDY Voltmeter does not register charge + Defective wiring when engine runs at high idle + (Check, repair loose terminals, dis- connections) + Defective adjustment of fan belt Voltmeter flickers while engine is run- tension ning + Adjust fan belt tension. For details, see 24.11 WHEN REQUIRED on page 3-58.
Voltmeter registers extreme high charge + Defective alternator + (Replace) + Defective wiring + (Check, repair) Abnormal noise is generated from alter- + Defective alternator nator + (Replace) Starting motor does not turn when key + Defective wiring + (Check, repair) switch is turned to START + Insufficient battery charge + Charge Pinion of starting motor keeps going in + and out Insufficient battery charge + Charge Starting motor turns engine sluggishly I + Insufficient battery charge + Defective starting motor I + Charge + (Replace) Starting motor disengages before en- + Defective wiring 4 (Check, repair) gine starts + Insufficient battery charge + Charge I 16.3.2 CHASSIS PROBLEM MAIN CAUSE REMEDY I I When transmission steering lever is + Oil pressure of drive train is not + Add oil to specified level, see 24.4 moved to desired position, machine raised EVERY 50 HOURS SERVICE on does not start or traveling speed is slow 1.
Insufficient oil in drive train system page 3-36. 2. Clogged strainer in trans case + Clean strainer When transmission steering lever is + Steering clutch of moved side is not moved to turn machine, machine does disengaged not turn and goes straight + Brake of moved side is not actuated + Adiust brake. When brake pedal is depressed, ma- chine does not stop + Brakes out of adjustment + Adjust brake. Track comes off I + Track too loose Abnormal wear of sprocket + Track too loose or too tight + Adjust track tension, see 24.11 WHEN REQUIRED on page 3-58. Blade rises slowly, does not rise + Lack of hydraulic oil + Add oil to specified level, see 24.3 EVERY 10 HOURS SERVICE on page 3-31. 2-62