Komatsu — CLEAN INSIDE OF COOLING SYSTEM

. MAINTENANCE SERVICE PROCEDURE Mixing rate of water and antifreeze WARNING 4 - 24 To maintain the anticorrosion properties of Supercoolant (AF-NAC), always keep the density of Supercoolant d 68%. Supercoolant between 30% an When deciding t he ratio of antifreez e to water, check t he lowest temperature in the past, an d decide fro m the mixing table given belo w. er to estimate and temperature about 10°C (18°F) lower when deciding the mixing ratio. depends on the ambient temperature, but it should always be a minimum of 30% by volume amount of coolant x 100).

It i s actually bett er to estimate and temperature abou t 10°C (18°F) lowe r whe n deciding t he mixing r The mixing ratio depends on the always (antifreeze/total amount of coolant Even in areas wh ere it is not neces sary to prevent fre ezing, use Supercoolant ( AF-NAC) a t a mixing ra tio of at least 30% to prevent c orrosion of the co oling system. The freezing tem perature of undilut ed antifreeze is -1 5°C (5°F). Do not store u ndiluted an tifreeze at a temperature of below -15°C ( 5°F). Min.

atmospher temperature ic °C Ab °F ove -10 -15 -20 -25 -30 -35 -40 14 5 -4 -13 -22 -31 -40 Amount of antifreeze Liters US agl 73.5 88.0 100.5 113.0 122.5 132.3 142.0 19.42 23.25 26.55 29.85 32.36 34.95 37.52 Amount of Liters 171.5 157.0 144.5 132.0 122.5 112.7 103.0 US gal 45.31 41.48 38.18 34.88 32.37 29.78 Volume ratio (%) 30 36 41 46 50 54 58 Antifreeze is fla mmable, so keep it a way from flame. Antifreeze is tox ic. When open the d rain valve, be carefu l not to get wate r containing antifreeze o n you. If it get s in your eyes, flush your eyes with large amount o f fresh water and se e a doctor at once.

When changing the coolant or drain ing the coolant from the radiator before c arrying out repairs, ask a special ist company to handle any coo lant containing anti freeze, or contact y our Komatsu distributor. Antifreeze is toxic, so never pour it into e. stributor. A into drainage water ditches or drain it on to the ground surfac Use antifreeze a nd appropriatewat er for diluting. (for d etails, see "COOLANT A ND WATER FOR DILU TION (PAGE 4-6)") r the coolant. ll water or other such water supply must be used, contact your Komatsu distributor. use of an antifreeze density gauge to control the mixing proportions.

Use city water fo If river water, we ll water or other su ch water supply m ust be used, contact you r Komatsu distributor. We recommend use of an antifree ze density gauge t o control the mixin g proportions. Prepare a contai ner whose capaci ty is larger than th e specified coolant volum e to catch drained coo Prepare a hose t o supply antifreez e coolant and wat er. . Stop the ma chine on level gro und, then stop the