OPERATION 12.14 HOW TO ESCAPE FROM MUD Always operate the machine carefully to avoid getting stuck in mud. If the machine does get stuck in mud, use the following procedures to get the machine out. 12.14.1 WHEN ONE SIDE IS STUCK When only one side is stuck in mud, use the bucket to raise the track, then lay boards or logs and drive the machine out. If neces- sary, put a board under the bucket also. NOTICE When using the boom or arm to raise the machine, always have the bottom of the bucket in contact with the ground. (Never push with the teeth). The angle between the boom and arm should be 90 to 110 E . The same applies when using the inverted bucket.
12.14.2 WHEN BOTH SIDES ARE STUCK When the tracks on both sides are stuck in mud and the machine will not move, lay boards as explained above, and dig the bucket into the ground in front. Then pull in the arm as in normal digging operations and put the travel levers in the FORWARD position to pull the machine out. 12.15 WORK POSSIBLE WITH HYDRAULIC EXCAVATOR In addition to the following, it is possible to further increase the range of applications by using various attachments. 12.15.1 BACKHOE WORK When condition of the machine is as shown in the diagram at right, each cylinders maximum pushing excavation force is obtained when the bucket cylinder and link, arm cylinder and arm are at 90 E .
When excavating, use this angle effectively to optimize your work efficiency. 2-81