Komatsu — 24.5.5 CHECK FAN BELT TENSION, ADJUST

MAINTENANCE 24.5.5 CHECK FAN BELT TENSION, ADJUST Checking The belt would normally deflect by about 5-6 mm (.20-.24 in) when pressed with the finger (with a force of approximately 6 kg. (13 lb.)) at a point midway between the fan pulley and tension pulley. Adjusting 1. Loosen bolts and nuts (1) and (2). 2. Loosen the lock nut and move tension pulley (4) with adjustment bolt (3) so the belt deflects about 5-6 mm (.20-.24 in) (with a force of approximately 6 kg. (13 lb.). 3. Tighten the bolts and nuts (1) and (2) to fix tension pulley (4) in position. 4. Check each pulley for damage, wear of the V-groove, and wear of the V-belt.

In particular, be sure to check that the V-belt is not touching the bottom of the V-groove. 5. Replace the belt if it has stretched, leaving no allowance for adjustment, or if there is a cut or crack on the belt. 6. When the new belt is set, readjust it after operating for an hour. 3-53