WARNING: Failure to follow these safety precautions may lead to a serious accident. SAFETY On job sites where there is danger that falling or flying objects may hit the operators cab, select a guard to match the operating conditions in order to protect the operator. ! For breaker operations, install a front guard and stick a laminated coating sheet to the front glass. ! When carrying out demolition or cutting operations, install a front guard and top guard, and stick a laminated coating sheet to the front glass. ! When working in mines or quarries where there is danger of falling rock, install FOPS (Falling Objects Protective Structure) and stick a laminated coating sheet to the front glass.
! When carrying out the above operations, always close the front window. In addition, always ensure that everyone apart from the operator is a safe distance away and is not in danger from failing or flying objects. Be particularly careful to keep people at a good distance during cutting operations. ! The above recommendations assume that the conditions are for standard operations, but it may be necessary to add additional guards according to the operating conditions on the job site. Always contact your distributor for advice before starting operations. ! If the glass on the work equipment side is broken, replace it with new glass immediately.
If you put your hand out, it may get caught in the work equipment and this may lead to serious personal injury. ! The KAIC FOPS fulfills the standards and regulations of all countries, but if it is damaged or deformed by failing objects or by the machine rolling over, its strength will be reduced and it will be unable to ensure its basic function. If such problems occur, please contact your distributor for advice about repairs. If the machine catches fire, it may lead to serious personal injury or death. If a fire occurs during operation, escape from the machine as follows. ! Turn the starting switch OFF and stop the engine. !
If there is time, use the fire extinguisher to extinguish as much of the fire as possible. ! Use the handrails and steps to escape from the machine. The above is the basic method for escaping from the machine, but it may be necessary to change the method according to the conditions, so carry out practice drills at the job site. 1-7 PROTECTION AGAINST FALLING OR FLYING OBJECTS ESCAPE FROM FIRE