z Inspecting (1) Check the wax pallet and spring for damage. (2) Put the thermostat in a container of water, then heat the water slowly and check temperature with a thermometer. If the valve lift is 0.1 mm (starting to open) at temperature of 82 ° C and 10 mm or more (opening wide) at temperature of 95 ° C, the thermostat is normal. z Replacing thermostat and precautions for handling (1) Precautions for handling The wax pallet type thermostat does not react as quickly as bellows type one to a variation of temperature of coolant. Such relatively slow reaction is mainly due to the large heat capacity of the wax pellet type thermostat.
Therefore, to avoid a sharp rise of coolant temperature, it is essential to idle the engine sufficiently before running it. In cold weather, do not run the engine at overload or over-speed it immediately after engine starting. (2) When draining out or replenishing coolant, do it slowly so that air is bled sufficiently from the entire cooling system. (3) Replacing thermostat If the thermostat is detected defective, retrace with a new one. DL06 Diesel Engine Maintenance of Major Components 170