2) Compressor It is connected to the same shaft with the turbine to make a revolving assembly, and receive the revolving force of turbine, and sends air to the suction manifold by suctioning and compressing it. This is called as the compressor. 3) Bearing (1) Thrust bearing Thrust bearing force is applied to the turbine wheel and an arrangement is made for the shaft not to shift.
(2) Journal bearing Journal bearing (floating bearing) is adopted and it forms the double oil films at the inner and outer surfaces in comparison to the general stationary type so that the bearing may be able to rotate independently and consequently the double layers of films act as the damper to make the slipping speed on the bearing surface less than the rotating speed of shaft so that the dynamic stability may be obtained. 4) Sealing at compressor shaft In order for the compressed intake air and lubricating oil not to leak, a seal plate and a seal ring are made to the double structures. DL06 Diesel Engine Maintenance of Major Components 178