Doosan DL06 — Doosan DL06 User Manual

5.3.5. Routine inspection and maintenance Since the state of turbocharger depends largely on the state of engine maintenance, to perform the specified up keep thoroughly is needed. 1) Air intake system System the intake air system, care must be taken to the air cleaner. In case of oil passing type air cleaner, if the oil level is lower than the specified value, the cleaning efficiency get worse, if higher, the sucked oil pollutes a case. Particularly, for if the rotor were polluted, the balance adjusted precisely would be deviated to cause a vibration that may cause the stuck or abnormal wear by loading large force to the bearing, the perfect air cleaner must always be used.

In case of dry type filter, according to the indication of a dust indicator, cleaning must be done to make the intake air resistance as small as possible. 2) Exhaust system In exhaust system, a care must be taken to the gas leak and the stuck prevention if exhaust gas leaks from the exhaust pipe and turbocharger etc., for the super charging effect will be lowered, the installed states of various parts must be paid with careful attention.

Since the parts that reach to high temperature during operation such as the turbine room use the anti- heat nuts, a care must be paid not to mix with the general nuts and at the same time, bolt stuck preventing paint should be coated on the nut for the designated places. DL06 Diesel Engine Maintenance of Major Components 180 Operation Caution Reason During operation Following items must be confirmed. 1) Oil pressure At idling : 1.5 ~ 3.0 kg/cm2 At full load : 3.0 ~ 5.5 kg/cm2 2) When abnormal noises and vibration are generated, slow down the revolution and must stop it to investigate the causes. 1) If the pressure is too low, abnormal wear or stuck may be caused.

Or if too high, the oil leak may be generated. 2) If the engine operation were continued with abnormal noises and vibration, it causes the engine trouble that can not be repaired or some other troubles. At stop 1) At stopping the engine, perform the idling operation for 5 min. and then stop it. 1) After heavy load operation, if the engine were stopped suddenly, the heat would be conducted to bearing parts from red hot turbine wings that would result in burning the oil to cause the stuck bearing metal and revolving shaft.