122 OPERATION Vehicle Modifications Alterations to the vehicle, such as changes to the wheel base (either lengthening or shortening), the addition of an auxiliary lift axle or removal of a factory-installed auxiliary lift axle, or major body changes, such as conversion of a tractor to a truck or an axle, suspension or steering system component modification, are NOT allowed, as these changes will adversely affect performance of the road stability system. Should such changes be unavoidable, the system must be disabled by having a qualified technician replace the Advanced EC-60™ECU with a Premium EC-60™ECU. Location of the yaw rate/lateral acceleration sensor must not be altered.
When servicing is required, the sensors must be replaced with identical components using the original equipment mounting brackets and tightening torque specifications (20 N.m [15 lb-ft]). The following additional changes MUST NOT be made to an "as-built" vehicle: Changes to maximum steering angle (to the left or right) Changes to steer axle and/or drive axle track width Changing the front and/or rear brake drums to drums having a different flange thickness WARNING Failure to disable the RSA system on a vehicle that has been modified will result in serious vehicle braking and performance issues, including unnecessary system interventions.
These interventions could lead to a loss of vehicle control. In addition to disabling the system, any cab labels, such as warning and caution labels relating to the Bendix® ABS-6 Advanced with ESP® system located on the sun visor must be removed, and notations must be made to the operator’s manuals so that the vehicle operator has a clear understanding as to which ABS options are installed on the vehicle.