Mack Trucks — Mack RH Drive Australia 21630923 Manual

124 OPERATION Precautions When Installing Electrical Equipment Connecting electrically powered or electrically controlled equipment to the vehicle may cause interference with other vehicle components (e.g., the ABS system). The amount of interference will depend on the operating frequency of any new signals and the degree to which transient signals are coupled into the vehicle system. Note: Whenever new electrical equipment is installed, it is the obligation of the installer to ensure that the new equipment does not interfere with the proper operation of all other electrical systems on the vehicle. If new electrical equipment is installed, a vehicle checkout procedure should be performed.

1 Perform the checkout procedure under the following conditions: Engine running Brake system air pressure in operating range Vehicle stationary Brake pedal fully depressed 2 Operate the new equipment under all starting, running and shutdown conditions. 3 Listen for signs of air exhausting from ABS modulator valves (which is an indication of an interference condition). 4 Correct all interference conditions before operating the vehicle. Note: The center pin of the standard seven-pin trailer electrical connector has been standardized as the dedicated connection for uninterrupted power for trailer ABS. This pin is always hot when the tractor ignition is turned on.

DANGER Some trailers manufactured prior to the trailer ABS regulations may use the center pin to power certain trailer auxiliary equipment. The possibility exists that this auxiliary equipment may be unexpectedly activated by the truck or tractor electrical system, resulting in personal injury or damage to equipment. Caution must be used when connecting the trailer electrical connector to ensure that power to the center pin will not unintentionally activate any trailer auxiliary equipment.