140 OPERATION Double-Clutching Double-clutching is a way to bring the speed of the transmission gears into synchronization so that the shift can be made without a clash. The engine is used to speed up the countershaft for a downshift and to slow it down for an upshift. Note: For all nonsynchronized transmissions, double-clutching is necessary on downshifts and upshifts. It is advisable to use the torque-limiting clutch brake to engage first and REVERSE gears and to double-clutch for gear ratio changes. 1 Depress the clutch pedal and shift to NEUTRAL.
2 Release the clutch pedal and increase (downshift) or decrease (upshift) engine speed until it roughly corresponds to the road speed of the desired gear. 3 Depress the clutch pedal and complete the shift. Then release the clutch pedal. POWER TAKE-OFF (PTO) OPERATION If the vehicle is equipped with a Power Take-Off (PTO) unit, be sure to read the following section. PTO Precautions DANGER Power Take-Off (PTO) units and related equipment can be very dangerous. Any PTO installation, repair or replacement should include a warning indicator light which indicates PTO engagement. The light must be located close to the PTO control and clearly visible to the operator.
DANGER Always keep body parts and loose-fitting clothing out of the range of drivetrain components, or personal injury may result. DANGER Always be aware of the current PTO status (engaged or disengaged) and the position of the vehicle body (dump body controlled by PTO, etc.). Be sure to disengage the PTO when not in use. DANGER PTO units are driven by engine or drivetrain components (flywheel, crankshaft, transmission). Do not attempt to service the PTO and related units unless the engine is shut down.