Mack Trucks — Mack RH Drive Australia 21630923 Manual

MAINTENANCE AND LUBRICATION 209 Jump-Starting Engine If you encounter a situation in which it is necessary to jump-start an engine, use the following procedures. CAUTION To avoid damaging any electronic controllers when jump-starting a V-MAC vehicle, always turn the ignition switch OFF before connecting the batteries. 1 Connect positive (+) cable to positive (+) post of discharged battery. 2 Connect the other end of the same cable to the positive (+) post of the booster battery. 3 Connect the second cable, negative (-) side, to the other post of the booster battery. 4 Make the final connection to the negative (-) battery terminal of the stalled vehicle, and stand back.

5 Start the vehicle with the booster batteries and then start the stalled vehicle. Shut down the vehicle with the booster batteries and remove the cables in the reverse order of connection. WARNING Batteries which are to be linked together must be of the same voltage (12 to 12, 24 to 24). Take care to observe proper polarity when connecting batteries. Batteries produce explosive gases. Keep sparks, fal mes, cigarettes, etc., away from batteries at all times. Protect your eyes by wearing safety goggles. Be sure vehicles are NOT touching each other. WARNING Do NOT connect the fni al negative (-) connection to the frame of the stalled vehicle.

This would cause all current to fol w through the master ground circuit breaker resulting in overload.