Mack Trucks — Mack RH Drive Australia 21630923 Manual

212 MAINTENANCE AND LUBRICATION The headlight circuits are protected by SAE Type I (automatic reset-cycling) circuit breakers that automatically interrupt then restore the flow of current through the circuit in the event of an overload. This cycling will continue until the cause of the overload is repaired. SAE Type II (automatic reset, non-cycling) circuit breakers (if equipped) provide a complete circuit disconnect until the overload is corrected. The power to the affected circuit breaker must be shut off before the circuit breaker will reset itself. The circuit protection panel also provides access to battery, ignition and ground terminals for non-factory installed electronic equipment.

(On V-MAC chassis, there are two serial link terminals for easy local connection of a trip recording device.)