SAFETY INFORMATION 33 Seat Belt Maintenance Keep belt clean and dry. Clean with mild soap solution and lukewarm water. Periodically inspect the following areas and replace any inadequate parts: Buckle and Latchplate — The buckle and latchplate should mate easily with a solid click and release easily and quickly with moderate pressure on the release button. All metal seat belt components should be free of signs of damage, corrosion or rust. Webbing — The webbing should show no signs of wear, fraying or holes, and it should be reasonably free of dirt which could find its way into the retracting mechanism.
Retractors — The retractors should function smoothly and maintain an appropriate amount of tension. Loose webbing is an indicator that maintenance is needed; it’s likely that a too-loose belt will fail to tighten properly when necessary. Seat Belt Mounting Components — The tethering should be free of wear and debris; the webbing should show no signs of wear, fraying or holes; and the metal components should be free of signs of damage, corrosion or rust. DANGER Do NOT bleach or dye belt, as this may cause severe loss of strength. Do NOT install belt in a truck with a weakened fol or until the floor has been replaced or reinforced.
DANGER Seat belt assemblies must be replaced after an accident if they have been subjected to loading by occupants (even if no damage is obvious), or if they have been damaged by an accident (bent retractor, torn webbing, etc.). If there is any question regarding belt or retractor condition, replace the appropriate part.