Mack Trucks — Mack RH Drive Australia 21630923 Manual

INSTRUMENTS AND CONTROLS 67 STEERING COLUMN Combination Starter and Electrical Switch C0032682 This switch starts the engine (turn the switch clockwise) and activates the accessory relay (turn the switch counterclockwise). When the switch is turned ON (in a clockwise direction), a warning buzzer sounds if air system pressure is below 448 ± 34 kPa (65 ± 5 psi) or if there is low oil pressure. The buzzer shuts off as soon as sufficient air/oil pressure is restored. Steering Wheel Adjustment Adjusting (Tilt and Telescope) Push down on the foot pedal located at the right kick panel to adjust the wheel to any position within a pre-defined range.

Note that you must continue to hold the pedal down while adjusting. When the adjustment is complete, release the pedal. Turn Signal Lever Note: The turn signals are not self-cancelling and must be returned to the middle position manually The turn signal lever is located on the steering column. It performs a number of functions, including activating the high and low beams, signal switch and the hazard switch. The signal switch can be used for courtesy flashing of marker lights and for the flashing of high beams. WARNING Adjust the steering wheel position BEFORE attempting to move the vehicle to avoid losing control of the vehicle.