Mack Trucks — Mack RH Drive Australia 21630923 Manual

82 OPERATION 4. Using the Bulldog as a handle, pull on the hood to raise it over the engine. You may put one foot on the bumper if necessary. 5. Pull steadily on the hood until it comes over the center and stops fully open. Closing the Hood Note: Remember to remove all tools, rags and test equipment from the engine compartment before closing the hood. Locking the Hood To lock the hood, secure the rubber hold-down straps on each side of the hood. 1 With the hood down, set the rubber strap in position and force the locking discs into the hood latch. 2 Push inward on the plastic handle to lock the rubber strap in place. 3 Repeat this procedure on the other side of the hood.

WARNING NEVER take both feet off the ground to tilt the hood. Keep at least one foot on the ground to avoid a slip or fall. If it is difficult for you to raise the hood, get the help of someone who can lift from the rear of the hood. WARNING Little effort is required to open or close the hood. NEVER take both feet off the ground to tilt the hood. Keep at least one foot on the ground to avoid a slip or fall. WARNING Before closing the hood, be sure no one is in the way of the hood’s descent.