176 STARTING AND OPERATING CAUTION! Always be certain the anchor you select will withstand the load. NOTE: How to choose an anchor point: A secure anchor is critical to winching operations. An anchor must be strong enough to hold while winching. Natural anchors include trees, stumps and rocks. Hook the cable as low as possible. If no natural anchors are available when recovering another vehicle, your vehicle becomes the anchor point. In this case, be sure to put the transmission in NEUTRAL, apply the hand brake and block its wheels to prevent your vehicle from moving. Ideally, you'll want an anchor point that will enable you to pull straight in the direction the vehicle will move.
This allows the synthetic rope to wind tightly and evenly onto the spooling drum. An anchor point as far away as possible will provide the winch with its greatest pulling power. 7. Attach the Clevis/D-Shackle and Tree Trunk Protector. Attach the shackle to the two ends of the strap or chain and through the hook, being careful not to over tighten (tighten and back-off 1/2 turn). Clevis/D-Shackles Winch Box Remote Control Connector 8. Lock the clutch. Lock the winch drum by rotating the clutch lever on the winch to engage. 10. Put synthetic rope under tension. Using the remote control switch, slowly wind the rope until no slack remains.
Once the rope is under tension, stand well clear of it and never step over it. NOTE: Always ensure the clutch is fully engaged or disen- gaged. 9. Connect the remote control to the winch control box, located on the front fascia/ bumper. Be careful not to let the remote control cord dangle in front of the winch. If you choose to control the winch from inside your vehicle, always pass the remote through a window to avoid pinching the cord in the door. Always disconnect the remote control when not in use. Pulling Synthetic Rope Under Tension