STARTING AND OPERATING 199 When the LaneSense system senses the lane has been approached and is in a lane departure situation, the left lane line flashes yellow (on/ off). The LaneSense telltale changes from solid yellow to flashing yellow. At this time torque is applied to the steering wheel in the opposite direction of the lane boundary. C HANGING L ANE S ENSE S TATUS NOTE: Removing the tailgate will disable the rearview camera function. The LaneSense system has settings to adjust the intensity of the torque warning and the warning zone sensitivity (Early/Medium/Late) that you can configure through the Uconnect system Ъ page 231. Manual Activation Of The Rear View Camera 1.
Press the "Controls" button located on the bottom of the Uconnect display. For example: If approaching the left side of the lane the steering wheel will turn to the right. NOTE: When enabled the system operates above 37 mph (60 km/h) and below 112 mph (180 km/h). 2. Press the "Backup Camera" icon to turn the Rear View Camera system on. 4 Use of the turn signal suppresses the warnings. The system will not apply torque to the steering wheel whenever a safety system engages (Anti-Lock Brakes, Traction Control System, Electronic Stability Control, Forward Collision Warning, etc.).
PARKVIEW REAR BACK UP CAMERA When the vehicle is shifted out of REVERSE (with Camera delay turned off), the rear Camera mode is exited and the previous screen appears again. When the vehicle is shifted out of REVERSE (with Camera delay turned on), the rear Camera image will be displayed for up to 10 seconds after shifting to another gear, unless the vehicle speed exceeds 8 mph (13 km/h), the transmission is shifted into PARK, the ignition is placed in the OFF position, or the touchscreen button “X” to disable display of the Rear View Camera image is pressed.
Lane Crossed (Flashing Yellow Lane Line) With Flashing Yellow Telltale The ParkView Rear Back Up Camera allows you to see an on-screen image of the rear surroundings of your vehicle whenever the gear selector is put into REVERSE. The image will be displayed on the Uconnect display screen along with a caution note to “Check Entire Surroundings” across the top of the screen. After five seconds this note will disappear. The ParkView Camera is located in the center of the tailgate handle. NOTE: The LaneSense system operates with similar behavior for a right lane departure.
Whenever the Rear View Camera image is activated through the "Backup Camera" button in the Controls menu, and the vehicle speed is greater than, or equal to, 8 mph (13 km/h), a display timer for the image is initiated. The image will continue to be displayed until the display timer exceeds 10 seconds.