GETTING TO KNOW YOUR VEHICLE 21 can be used to start and operate the vehicle. The system cannot reprogram a key fob obtained from another vehicle. IGNITION SWITCH The push button ignition can be placed in the following modes: K EYLESS E NTER N G O GNITION OFF After placing the ignition switch in the ON/RUN position, the Vehicle Security Light will turn on for three seconds for a bulb check. If the light remains on after the bulb check, it indicates that there is a problem with the electronics. In addition, if the light begins to flash after the bulb check, it indicates that someone attempted to start the engine with an invalid key fob.
In the event that a valid key fob is used to start the engine but there is an issue with the vehicle electronics, the engine will start and shut off after two seconds. This feature allows the driver to operate the ignition switch with the push of a button as long as the key fob is in the passenger compartment. The engine is stopped Some electrical devices (e.g. power locks, alarm, etc.) are still available 2 The START/STOP ignition button has several operating modes that are labeled and will illuminate when in position. These modes are OFF, ACC, ON/RUN, and START. ACC Engine is not started Some electrical devices are available (e.g.
power sunroof, power windows, etc.) RUN If the Vehicle Security Light turns on during normal vehicle operation (vehicle running for longer than 10 seconds), it indicates that there is a fault in the electronics. Should this occur, have the vehicle serviced as soon as possible by an authorized dealer. Driving position All electrical devices are available (e.g. climate controls, heated seats, etc.) START The engine will start (when foot is on the brake) CAUTION! NOTE: If the ignition switch does not change the mode by pushing the button, the key fob may have a low or depleted battery. In this situation, a back up method can be used to operate the ignition switch.
Put the nose side (side opposite of the emergency key) of the key fob against the START/STOP ignition button and push to operate the ignition switch. The Sentry Key Immobilizer system is not compati- ble with some aftermarket remote starting sys- tems. Use of these systems may result in vehicle starting problems and loss of security protection. Keyless Push Button Ignition 1 — OFF 2 — ACC (Accessory) 3 — ON/RUN All of the key fobs provided with your new vehicle have been programmed to the vehicle electronics Ъ page 437.