IN CASE OF EMERGENCY 335 6. Block both the front and rear of the wheel diagonally opposite the jacking position. For example, if the driver’s front wheel is being changed, block the passenger’s rear wheel. the front of the cover is loose, slide the cover toward the front of the seat until it is free from the seat frame. Remove the jack and tools from the bracket assembly. Turn the jack turn-screw counterclockwise to release jack from bracket assembly. Wheel Blocked Jack Access Cover Jack And Tools Bracket Assembly NOTE: Passengers should not remain in the vehicle when the vehicle is being raised or lifted.
J ACK L OCATION Remove the jack and tools by turning the wing bolt counterclockwise, remove the wing bolt and then slide the assembly out from under the seat. 7 The jack and tools are stored under the front passenger seat. R EMOVAL O F J ACK A ND T OOLS To access the jack and tools, you must remove the plastic access cover located on the side of the front passenger’s seat. To remove the cover, pull the front part of the cover (closest to the front of the seat) toward you to release a locking tab. Once Jacking Tools Wing Bolt/Jack And Tools