SERVICING AND MAINTENANCE 401 REAR LAMP BAR ID MARKER (DUAL REAR WHEELS) — IF EQUIPPED Tire Markings See below steps to replace: 1. Loosen the two screws and the housing to gain access to the bulb sockets. Side Marker Lamp Locations 1. Push rearward on the side marker lamp assembly. Tire Markings 2. Pull the entire assembly from the fender. 1 — US DOT Safety Standards Code (TIN) 2 — Size Designation 3 — Service Description 4 — Maximum Load 5 — Maximum Pressure 6 — Treadwear, Traction and Temperature Grades Screw Locations 3. Turn the socket a quarter turn counter- clockwise and remove from assembly to access the bulb. 2. Turn the socket a quarter turn counter- clockwise to access the bulb.
4. Pull the bulb straight out from socket. 3. Pull the bulb straight out from the socket. 5. Reverse the procedure for installation of the bulbs and housing. 8 4. Reverse the procedure for installation of the bulbs and housing. TIRES SIDE MARKER LAMPS (DUAL REAR WHEELS) — IF EQUIPPED T IRE S AFETY I NFORMATION See the following steps to replace: Tire safety information will cover aspects of the following information: Tire Markings, Tire Identification Numbers, Tire Terminology and Definitions, Tire Pressures, and Tire Loading.