RAM 2500/3500 — Reset Auto-Up

74 GETTING TO KNOW YOUR VEHICLE The passenger door windows can also be operated by using the single window controls on the passenger door trim panel. The window controls will operate only when the ignition is in the ACC or ON/RUN position. A UTOMATIC W INDOW F EATURES NOTE: Any impact due to rough road conditions may trigger the auto-reverse function unexpectedly during auto-closure. If this happens, pull the switch lightly and hold to close the window manually. Auto-Down Feature The driver and front passenger door power window switches have an Auto-Down feature. Push the window switch down for a short period of time, then release, and the window will go down automatically.

To open the window part way (manually), push the window switch down briefly and release. WARNING! NOTE: The power window switches will remain active for up to 10 minutes after the ignition is placed in the OFF position. Opening either front door will cancel this feature. The time is programmable within Uconnect Settings Ъ page 231. To stop the window from going all the way down during the Auto-Down operation, pull up or push down on the switch briefly. There is no anti-pinch protection when the window is almost closed. To avoid personal injury be sure to clear your arms, hands, fingers and all objects from the window path before closing.

Auto-Up Feature With Anti-Pinch Protection Lift the window switch up for a short period of time and release; the window will go up automatically. WARNING! To stop the window from going all the way up during the Auto-Up operation, push down on the switch briefly. R ESET A UTO -U P Never leave children unattended in a vehicle. Do not leave the key fob in or near the vehicle or in a location accessible to children, and do not leave the Keyless Enter ‘n Go™ Ignition in the ACC or ON/RUN position. Occupants, particularly unattended children, can become entrapped by the windows while operating the power window switches. Such entrapment may result in serious injury or death.

Should the Auto-Up feature stop working, the window probably needs to be reset. To reset Auto-Up: To close the window part way, lift the window switch briefly and release it when you want the window to stop. 1. Pull the window switch up to close the window completely and continue to hold the switch up for an additional two seconds after the window is closed. If the window runs into any obstacle during auto-closure, it will reverse direction and then go back down. Remove the obstacle and use the window switch again to close the window. 2.

Push the window switch down firmly to open the window completely and continue to hold the switch down for an additional two seconds after the window is fully open.