RAM 2500/3500 — Disconnecting The Rear Camera And Remote Keyless Entry

78 GETTING TO KNOW YOUR VEHICLE C LOSING WARNING! To close the tailgate, push it upward until both sides are latched. To avoid inhaling carbon monoxide, which is deadly, the exhaust system on vehicles equipped with “Cap or Slide-In Campers” should extend beyond the overhanging camper com- partment and be free of leaks. The tailgate can be locked using the key fob lock button. T AILGATE R EMOVAL NOTE: Removing the tailgate will disable the rearview camera function. To remove the tailgate, follow the instructions below: Disconnecting The Rear Camera And Remote Keyless Entry Locking Tang 1.

Open the tailgate to access the rear camera or Remote Keyless Entry connector bracket located on the rear sill. 3. Position the tailgate on a 45 degree angle. 4. Raise the right side of the tailgate until the right side pivot clears the hanger bracket. 1. Disconnect the wiring harness for the rear camera and or power locks (if equipped) Ъ page 78. 2. Unlatch the tailgate and remove the support cables by releasing the lock tang from the pivot. 5. Slide the entire tailgate to the right to free the left side pivot. 6. Remove the tailgate from the vehicle. NOTE: Make sure tailgate is supported when removing support cables. NOTE: Do not carry the tailgate loose in the truck pickup box.

Connector Bracket