Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE NOTICE 4 - 76 20. Remov e the cap from bleeder screw (10) and insert a commercially available vinyl hose.) e other end of the vinyl hose approx. 50 mm i er of oil. vinyl nto a n the m the (10) hose. (Use a 21. Put th contain 22. Loose engine n bleeder screw (10) approx. 3/4 turns and ru at low idling until no more bubbles come out fro ose. no more bubbles come out, tighten bleeder screw vinyl h 23. When secure ly, remove the vinyl hose, then install the cap. 24. Carry o ut the warming-up operation of the engine until th e torque converter oil temperature gauge goe 40°. the torque converter oil temperature gauge rises to 40°, bleed the air from the brakes.

rake: See "BLEED AIR FROM FRONT BRAKE (PAGE 4-42)". rake: See "BLEED AIR FROM REAR BRAKE (PAGE 4-41)". g brake: See "BLEED AIR FROM PARKING BRAKE (PAGE 4-43)". 25. When the torque converter oil temperature gauge rises t Front b rake: See "BLEED AIR FROM FRONT BRAKE ( Rear b rake: See "BLEED AIR FROM REAR BRAKE (P Parkin g brake: See "BLEED AIR FROM PARKING BRA Do not at tempt to use the oil drained during air bleeding again. S uch a practice can cause damage on the machine's equipme Make sur e that the oil level in the brake oil tank does not go dow n below (H) level in the sight gauge during air blee does, the 26. specifi ed level.

For details, see "CHECK OIL LEVEL IN TRANSMISSION CASE, ADD OIL (PAGE 3-7 27. Check the oil level in the brake sub-tank and adjust the oil level so that it reaches the specified level. For see "C