Komatsu — HANDLING EXTERNAL POWER SOURCE TYPE ELECTRIC HEATER

. ATTACHMENTS, OPTIONS EXTERNAL POWER SOURCE TYPE ELECTRIC HEATER MANUFACTURING EXTERNAL POWER SOURCE INPUT CABLE per the cable according to the table below. CAUTION 6 - 97 It is required to purchasing This does not mean that an When purpose the cable, m ake sure that it the following spec CABLE SPECIFICATIONS AND INSTALLING PROCEDURE 1. Purchase locally 3-core chloroprene sheath cabtyre ca referring to the specifications in the diagram on the right. The nominal cross-section area should be 5 - 8mm2. Select a cable that is able to stand voltage of 3000V minute. To prevent any drop in voltage, make the length less t 30m (98ft 5in). 1.

Purchase locally 3-cor referring to the specific The nominal cross-s Select a cable that minute. To prevent any drop 30m (98ft 5in). . Purchase locally 3-cor ations in the diagram on the right. ection area should be 5 - 8mm2. is able to stand voltage of 3000V in voltage, make the length less t . Connect a plug (175-0 the connector and each one is ma rked with a contact symbol, Solder the contact and core wire to connect them. To prevent short circuits ca used by contact between the conducto rs, insulate the soldered parts Always use plug 175-06-378 71. If another plug is sued, it ca nnot be connected with the external p ower source input socket (rece