. ATTACHMENTS, OPTIONS EXTERNAL POWER SOURCE TYPE ELECTRIC HEATER CONTROL METHOD WARNING NOTICE REMARK 6 - 100 HANDLING PROCEDUR This is a st arting aid to use i n seasons when the ambient temperature goes down to -20 - -40°C (-4 - -40 °F), or e ven in temper atures above that if it is difficult to start the engine because of th Stop the machine on level g Always check that the pow er switch is at the OFF position. It is extremely dan gerous to connect the cable when t he p ower switch is at the ON position Check th at the ground conn ection is securely grounded before turning the pow Do not star t the engine while t he electricity is turned on.
Always turn the power s witch OFF before starting the engine. I f the engine is st arted with the elect ricity still turned on, it will cause failure of the coola If the mac hine is covered w ith a tarpaulin, the engine startup becomes ea 1. If it is a nticipated when finishing the day's work that the engine preheat er will be used again at the next r un, park the m achine within the reach of the power unit with an external power input cable. 2. Activa te the engine pre heater several hours before each engine startu p, following the steps below, so tha t the engin 1) Co e cooling water a nd oil in the engine oil pan can be timely warm ed up. side with a cable.
nnect the power unit and the power input outlet on the machine 2) Tu if i 3. When in the 4. Start t rn on electricity w ith a power switch (main switch) or a separate p ower on and off switch of the power unit, t is provided. 3. When preheating work is finished, turn off the power switch, disconne ct the cable and screw a protective cap power input outle t (receptacle) on the machine side securely. 4. Start t he engine.