Komatsu — 4.6.6 RESETTING THE ENGINE OIL BURNING SYSTEM CENTINEL

MAINTENANCE 4.6 LUBRICATION AND MAINTENANCE SCHEDULE Extended Service Intervals for Engines with Engine Oil Management System Every 500 operating hours The contents of the engine oil reserve tank is sufficient for approximately 500 hours of operation. The oil level in the reserve tank is also monitored by the ETM system. Be sure to fill the reserve tank when the information message "Engine oil reserve tank empty" is being displayed on the ETM screen. Fill the reserve tank via the swing down service arm. Use engine oil according to the specifications in the Engine Operation and Maintenance Manual. Change both oil filter cartridges (3) of the reserve system.

Every 4000 operating hours Change engine oil. Drain the oil from the engine oil pan and from the engine oil reserve tank. See illustration Z23083 on page page 265 for location of the drain plug on the reserve tank. It is recommended to change the oil when the oil level in the reserve tank is near the minimum level. NOTICE After the engine oil has been drained from the engine oil pan and from the reserve tank, fill the engine oil pan and the reserve tank via the swing down service arm. See section "Central Refilling System" on page 218 for more information. DO NOT use the oil in the reserve tank to fill the engine oil pan after an oil change.

Refer also to the Engine Operation and Maintenance Manual for oil change procedure and oil specifications. 4.6.6 RESETTING THE ENGINE OIL BURNING SYSTEM CENTINEL Resetting of the Centinel system is necessary in the following cases: After every engine oil change. Whenever the engine oil reserve tank has been allowed to run empty. After repairs on the Centinel system. When changing the engine oil quality from Mineral oil to Syn- thetic oil and vice versa. For resetting procedure refer to page 69 in section 3.2 263