Komatsu — 3.4.3 FUNCTIONS OF THE ETM SYSTEM

OPERATION 3.4 ELECTRONIC TEXT MONITORING SYSTEM ETM Message Classification The 60 possible messages are classified as follows: Fault messages are stored in the record memory and also kept in the statistics memory. When these messages are dis- played, an acoustic signal is heard. Information messages are identified by the sign (#) in the upper LH corner of screen (A). Information messages are not stored. The message pages (number 27 to 30) are used for settings of the ETM. REMARK The messages are divided into four groups according to their priority.

3.4.3 FUNCTIONS OF THE ETM SYSTEM After switching on the excavator’s key operated main switch, the name of the manufacturer will be displayed for a period of 5 sec- onds. NOTICE If during this period a key is being actuated, the manufactur- ers name remains on the screen for further 20 seconds. Thereafter the basic ETM display appears on the screen. This display is for general information during operation. If a fault or an information condition occurs during operation, the basic display is automatically replaced by a message in text.

If a further condition occurs, the message will be displayed if it is more important than the present message on the screen, so that the operator is always shown the latest, most important message. A flashing number on the screen shows the total number of the current messages. The message text provides the operator with an explanation of the condition in standard texts as listed in the annexes “Message Texts”. When a fault message is displayed the number of operating hours is displayed at the same time. Information conditions are held as long as they occur, but are not stored. Basic Display (message page no. 0): DATE: TIME OF DAY: OPERATING HOURS (h): ENGINE RPM (1/min): TRUCK COUNTER: 95