OPERATIONAL PERFORMANCE TEST / Standard OPERATIONAL PERFORMANCE STANDARD TABLE The standard performance values are listed in the table below. Refer to the Group T4-3 or later for performance test procedures. The following switch positions shall be selected and the hydraulic oil temperature shall be maintained as indicated below as the preconditions of performance tests unless otherwise instructed in each performance test procedure: Acceletor Pedal : Full Stroke Driving Mode Switch : H Mode Work Mode Switch : N Mode Hydraulic Oil Temperature : 50 ± 5 ° C (122 ± 9 ° F) T4-2-1 NOTE:
1 mm=0.03937 in PERFORMANCE TEST DESIGNATION Performance Standard Remarks Reference Page ENGINE SPEED min-1 T4-3-1 Slow Idle Speed (without load) 900±25 Value indicated on Dr. ZX Fast Idle Speed (without load) 2320±25 ↑ Fast Idle Speed (with engine stalled) 2150±50 ↑ Fast Idle Speed (with engine stalled and relieved) 1720±50 ↑ ENGINE COMPRESSION PRESSURE MPa (kgf/cm2, psi) 3.04 (31.0, 442) Engine speed: 200min-1 - VALVE CLEARANCE (IN, EX) mm 0.254, 0.508 With the engine cold - LUBRICANT CONSUMPTION (Rated output) mL/h 50 or less Hour meter: 2000 hours or less T4-3-3 DRIVE BELT BEND mm 6 to 8 T4-6-8 RADIATOR CAP OPENING PRESSURE kPa (kgf/cm2, psi) 49 (0.5, 7) -