WHEN REQUIRED k. CLEAN AXLE CASE BREATHER Carry out this procedure if there is any mud or dirt stuck around the breather. I. CHECKING OF GLOW PLUG OF APS (Automatic priming system) Checking is performed in autumn (when the ambient temperature is below 15’C). 1. Remove the two glow plugs from the engine intake manifold, and clean them. 2. Check for any disconnection in Front Rear ,, ,., ,,, the wiring. 3. Replace the gasket with a new part, then install the glow plug. Remove all mud and dirt from around the breather with brush. Then, remove breather, immerse in cleaning fluid and clean. Clean the breathers of the front and rear axles in the same way.
Do not let dirt get into the port while breather is removed. If dust sticks to area around breather, clean with a brush. - 116- W-04326