Komatsu — SAFETY HINTS

BEFORE STARTING OPERATION CHECK BEFORE STARTING CHECKING JOBSITE CONDITIONS l Examine the lay of the land and the kind of soil at the work site to determine the dangerous points and the best method of operation. Proceed with the work only after making safety arrangements l Check the load limits of bridges before crossing. l Carry out checks before starting the machine. If any problem is found, do not start the engine, but inform the foreman immediately. Always keep the machine in good condition. l When operating a machine in water or fording streams, survey the water depth, ground condi- tion and velocity of the water in advance.

Do not take the machine in water exceeding the allowable depth (up to the underside of the axle housing). l Before operating the machine, be sure to check the bar and pins for setting in storage position. The machine can not be steered with frames locked. (In articulate frame model) l Do not work when visibility is re- about the dangerous points. duced by smoke, fog or dust. If the jobsite is dark, install lighting if necessary. l The overall height of the machine is restricted by tunnels, roof height or overhead electric wires, SO check first whether the jobsite is safe.

Be particularly careful when working near power lines as electric shock can be caused if the machine touches the electric cables. l Keep work site flat! By continually grading the work site, work efficiency will be im- proved and machines will be able to drive smoothly over the site. If the work site is very sandy or dusty, sprinkle water over the ground before working on the site. l Always stop the engine when adding fuel. After adding fuel, tighten the fuel cap properly. l Inspect the inside of the engine room and remove any dead leaves or papers. Dead leaves or papers are highly inflammable and can cause fires. W-01242 -3-