Komatsu — OPERATING THE CAR HEATER

OPERATING THE CAR HEATER OPERATING THE CAR HEATER EQUIPMENT ON CONTROL PANEL It is possible to use the car heater to good effect in dusty jobsites. The outside air is passed through the filter and is sent to the operator’s cab to increase the pressure inside the cab. In this way, dust is prevent- ed from entering, so comfortable operating conditions are always maintained for the operator. @Fan switch l This controls the air flow when the car heater is used for heating. 0 There are 3 levels: 0 Air selector lever l This lever switches the source for the heating air. 0 FRE (fresh air) Fresh air is brought into the heating system from outside.

,(This position is used for normal heating, and when in- creasing the pressure inside the cab.) L (Low). M (Medium) and H (High) @ Temperature control lever l This lever regulates the tempera- ture when heating. o The closer the lever is to WARM, the higher the tem- perature of the air becomes. o REC (recirculate) The heating system uses only the air inside the cab. (This po- sition is mainly used for heat- ing the air inside the cab quickly.) -21 - W-03825