Komatsu — STORAGE

STORAGE DURING STORAGE l Operate the engine and move the machine for a short distance once a month so that new oil film will be coated over movable parts and component surfaces. After storage (when it is kept without cover or the rust-preventive operation once a month is not made), you shall apply the following treatment before operation. AFTER STORAGE l You should request Komatsu dis- tributor for following service. o Remove the cylinder head cover and lubricate sufficiently valves and rocker arms. And inspect the valve operation. o Remove the oil pipe flange on the turbocharger oil inlet, fill with 0.5 to 1 I! engine oil, and leave the flange lightly loosened.

Then, rotate the engine by the starting motor without fuel injection and decompression so that the dis- charge of oil is confirmed. Then, tighten the flange and start the engine. l Before operating the work equipment, wipe off the grease on the hydraulic piston rod. A If it is unavoidably necessary to carry out rust-preventive op- eration while the machine is indoors, open up doors and win- dows to improve vetilation and prevent the gas poisoning. l Wipe off the grease on the hy- draulic piston rod. l Loosen the drain plugs on oil pan and other cases and drain mixed water. l After the engine is started, oper- ate it until it is warmed up completely. - 30 - ww-01374