REMOVAL AND INSTALLATION OF BUCKET 3. Remove mounting bolt (5) of 4. flange. Before pulling pin, be sure to or remove mounting bolt of flange. Otherwise the seal will be damaged. Sling the bucket link, then pull out the bucket link pin. Secure the bucket link to the tilt lever with wire. Installing the bucket 1. Assemble O-ring (2) on flange * * (1) of bucket pin. Assemble O-ring after coating with grease. 2. Check that there is nothing wrong with the oil seal (2) and dust seal (3) that are assembled on flange (I), and that dust seal is assembled 0 to 0.5 mm from edge of flange (I), or that there is no clearance between dust seal (3) and oil seal (2). 5.
Pull out and remove pin (6) on both sides of bucket. Disconnect lift arm and bucket, 6. W-03778 - 35 -