TANDEM PUMP REPLACEMENT 2.9 14 Reinstall the steering control linkages and locks as outlined in Section 4. and install access cover with 2 bolts. ( fig. C3485 ) Replace control linkage IMPORTANT 2 Follow the start up procedure outlined in section 2.8 upon restarting after pump repairs or replacement. 15 Fill the hydraulic oil reservoir to the proper level. 16 Follow the start up procedure outlined in section 2.8 before attempting to start the loader. 17 The start up must be made with the loader raised securely from the ground. Changing the pumps and the steering control linkages has affected the neutral adjust- ment.
Failure to raise the loader clear of the ground may result in the loader engaging in motion and possibly caus- ing serious injury. C3485 Hydraulic reservoir filler cap WARNING This start-up procedure must be made with the loader securely raised off the ground. 18 Start the loader and check for leaks. Make repairs as necessary and replenish the hydraulic oil reservoir (fig. C1108, C3431). Never use your hands to check for hydraulic leaks. C1108 WARNING Reservoir sight gauge To prevent personal injury never make repairs to the hydraulic system while the engine is operating. 19 Make adjustments to the steering controls, steering locks, and restraint bar cables as required.
Follow the pro- cedures for control adjustments in Section 4 WARNING Use caution when dealing with hydraulic fluid under pressure. Escaping fluid under pressure can pene- trate the skin and cause serious injury. C3431 2-19