Komatsu — 4.7.11.e CHANGING THE FUEL FILTER

MAINTENANCE PLAN 4.7.11.e CHANGING THE FUEL FILTER DANGER Change the filtering element after work, when the engine has cooled down to 40-45°C. When these operations are carried out, fuel may be spilled; clean the dirty areas immediately, in order to prevent any risk of slipping or fire. Oils, filters, coolants and batteries are considered special waste and must be collected and disposed of according to the anti-pollution regulations in force. 173 The fuel filter and the fuel pump can be reached by opening the engine hood (See “3.5.1 ENGINE HOOD”). FUEL FILTER 1 - Clean the outer surfaces of the unit and with the special span- ner provided unscrew the used filter (1) and throw it away.

2 - Clean the inside of the head (2). 3 - Lubricate the seal of the new filter and screw thoroughly. 4 - Give another half turn by hand. 5 - Bleed the fuel supply circuit. BLEEDING THE CIRCUIT After filling the tank, proceed as follows: 1 - Loosen the drain screw (3) of the filter holder head (2). Use a 12 mm spanner. 2 - Unscrew the knob (4) of the fuel pump (5) completely. 3 - Act on the knob (4) until fuel without any trace of air flows out of the filter head. Tighten the drain screw (3). 4 - Press the knob (4) and tighten it completely. 5 - Start the engine.

2 1 RWAA1230 3 RWAA1240 4 5 2 1 RWAA1230 IMPORTANT • If the fuel does not flow when the fuel pump lever is operat- ed, give one turn to the driving shaft. • Do not let the starter run for more than 15 seconds. Wait at least 15 seconds before repeating the starting procedure. • If the engine starts without problems and then stops or works irregularly, check if there is air in the circuit; if so, check the tightness of the fuel filter, the water separator and the fuel pump. • After the fuel has run out, bleed the circuit by proceeding as described above. 4 5 RWAA1250 RWAA1250