PRECAUTIONS TO BE TAKEN DURING MAINTENANCE 2.8 PRECAUTIONS TO BE TAKEN DURING MAINTENANCE 2.8.1 WARNING PLATES Before starting any maintenance operation, position the ma- chine on a firm and level surface, rest the equipment onto the ground, engage the safety locks of either the equipment and the controls and stop the engine. If another person starts the engine and operates the control le- vers while the operator is providing for service, this may result in serious injuries or even death.
DO NOT START ENGINE To avoid these risks, always attach warning plates to the control levers and to the ignition key before performing any mainte- nance operation; if necessary, attach additional warning tags al- so around the machine and in particular on the cab handles. RWA01210 2.8.2 TOOLS Use only the tools provided with the machine and high-quality tools suitable for the tasks to be performed. Do not use worn, damaged, low-quality tools or tools that are not suitable for the tasks to be performed, in order to avoid any personal injury. After use, always clean the tools carefully and put them in the appropriate compartment (1) positioned inside the engine hood, on the left side.
RWA01310 1 RWA18700 2.8.3 PERSONNEL Only authorized and duly trained personnel can service and repair the machine; additional precautions must be taken when grinding, welding and using a sledge hammer or heavy hammers. When assemblying the equipment or cylinder connection pins, use wooden, plastic or in any case not excessive- ly hard tools to check the centering of the holes. Do not use your fingers, since you run the risk of cutting them. 42