Komatsu — OPERATIONS AND CHECKS AFTER STARTING ENGINE

. OPERATION OPERATION speed from time to time. 3 - 71 STARTING IN COLD (Ambient temperature b After the engine starts immediately. First, carry out the following operations and checks. When the hydraulic oil is or move the levers su at low temperature, do not carry out operations ddenly. Always carry out the warming-up operation. This will help Do not accelerate the eng to extend the machine life. ine suddenly before the warming -up operation is completed. Do not run the engine at low idling or high idling continuo usly for more than 20 minutes. This wi ll cause damage to the environme nt. It will also cause damage to the inte rnal parts of the turbocharger an d engine.

If it is necessary to run the e ngine at idling, apply a load or ru n at mid-range 1. Pull fuel control lever (1) to a position midway bet ween the low idling and full speed speed, and continu minutes. positions, run the engine at a mid-range e to run under no load for approx. 10 2. Operate blade contro l lever (3) fully to the RAISE p osition, t hen hold the lever in posi and right tilt relief in t tion, and operate slowly to th e left tilt r elief urn for 5 minutes. 3. After this, operate th e blade control lever (3) fully t o the RAISE position, hold the lev tilt intermittently.

N position and lower t lever fully to the FLO relieve the left and ri er in position, and relieve the left and r ight ext, operate the lever to t he blade to the ground, then he LOWER operate the AT position, hold the lever in position, and ght tilt in turn intermittently fo r 5 minutes.